Donystoy's latest activity
-
DDonystoy reacted to Old Machinist's post in the thread Need help removing this part from bushhog with
Like.
That is pretty obvious it's a splined hub on a splined shaft. It ain't gonna turn. You might be able to get a bearing puller on it. Heat... -
DDonystoy replied to the thread B7800 front axle ball bearing question.Interesting thread! When I overhauled both spindles on my B7200 I obtained all parts including bearings from the dealer. Nothing was...
-
DDonystoy replied to the thread Box or Grading Scraper?.I use a scraper blade turned in reverse to move gravel on my 4000 foot driveway. Finishing is done with towing a 4 x 8 foot piece of...
-
DDonystoy reacted to North Idaho Wolfman's post in the thread B7800 front axle ball bearing question with Like.
Kubota parts are never press fitted, except in some very rare instances and this is not one of them. They are normally held in place...
-
DBecause the B7100 only has a low output dynamo. A good fan will wipe out the battery in nothing flat. If it's overheating with the...
-
DDonystoy replied to the thread 2023 LX3310 3 point hitch operating range..When you place the lever in the full lift position does it go all the way up? From the look of my service manual the lever attaches to a...
-
DDonystoy replied to the thread Snowblower Hydraulic Chute movement question.Not sure why they went with the regenerative system but my b7200 did not have it and quite frankly I preferred it. I like to be able to...