Recent content by dkforge

So I just had my L2501DT delivered and am looking at box blades. I've read every thread I can find in trying to decide between a 5' and 6' box blade. I think a 66" would be ideal based on the tractor with R1's being 66" but trying to find a 66" is proving challenging. So here is a poll to let me...

Thanks for all of the responses!

Going to have to replace the instrument panel($422), water made it's way in this winter and froze damaging the tach needle and panel. Any suggestions on how to clean this connector so I don't end up having to buy a new wiring harness also ($600+). I've always kept it under a carport but that...

Hi guys. I have a 2014 RTV1120D and the handle for the hydraulic dump bed would not move at all (yes the safety latch was pushed aside). In trying to get it to move the cable snapped right where it is connected to the handle behind the drivers seat. I need to raise the bed to replace the cable...

Thanks Mike that's just what I needed!

So it appears I have a leaking power steering hose on my BX2670. I can see where the two hoses are in a sleeve and run from under the dash down the left side of the tractor to the front axle. Has anyone replaced these before and if so any suggestions on how to remove the ends that are under the...

Thanks for the replies still trying to nail it down will post what I find. Bruce you've been watching too many of those bizarre food shows. Bunnies in hydraulic fluid sounds like a real treat.

While mowing my BX 2670 started losing pto power. Checked hydraulic fluid dip stick and fluid was all frothy. Let it sit a while ran fine. Started again and got frothy and losing power. Anyone else run into this. Ideas? Thanks

Hello, new member and hopefully new bx2670 owner. I will be buying one this week and am looking at existing storage options at the homestead. Can someone give me the actual length and width of a bx2670 with FEL and 60" mmm. I know they call it a 60" mmm but didn't know the actual overall width...