Recent content by des57

Thanks guy's , I have a 60'' brush hog that I do all the big cutting with on my coot ATV ( army mule ) any way I need some thing to get between trees , so it will not be cutting thick brush, but nice to know the right size BH I should be looking for , thanks guy's.

I guess my oil pressure sensor was bad, put on a mechanical gauge and guess what ( this is running in heated garage, so not hot running yet ) 65 psi full throttle and 55 psi at low idle. Not bad for a B6100D , that's with a oil change w/ Valvoline 15-40 diesel.

looking for a 48'' brush hog mower for my b6100d

I have a B6100 D , got it in a auction , ran it a little, just playing , low oil pressure light would flicker when idling . I changed the oil and filter , used Valvoline HD diesel 15-40.Now light is on all the time. I want to install a oil pressure gauge , what should the pressure be , no hour...

I have a B6100E that has a plug or bolt on the bottom of the bell housing , A 14mm wench fits it, it has a nut welded to the bell housing, looks like a drain plug, all the books I have doesn't show it . There shouldn't be any fluid in the bell housing that I know of.

Re: B7100 parts Do you have the hydraulic divert block w/ the two threaded ports, the block is on the smaller hyd steel line coming from your hyd pump to 3ph valve, Thanks

Checked a couple Kubota dealers and one did a search in usa not available.

Can someone tell me what type of hydraulic oil I should be using on a B6100. THANKS

Does any body have a power beyond hyd block w/ two threaded ports for a B6100 for sale. Thanks

No mid pto, front pto w/ elect clutch pulley

This site is great, love all the help THANKS eserv I did think of doing that idea of venting down pressure on cylinder , I have nice little vent filters in the garage, I don't have a valve on that 3ph port , so if I hook up to that port ( under the seat ) I should put a valve or quick coupler...

Dave the valve that came with it, to me is junk, I build hyd systems for my bigger trucks, this system is new to me, trying to figure this out. I have smaller hyd valves that will do any operation in my garage. There was nothing on this tractor as in hyd's, all I found was a port on my pb block...

It is double acting cylinder, if I did have a single acting where on the 3ph can I connect a hyd line .

I have a b6100 and I want to hook up a hyd cylinder for my new snow blower I bought. I have only one port on my power beyond block , I have a open circuit valve I know I have to get back to the pressure line do I cut and install a tee or is there a block adapter that goes at the banjo nut where...