Recent content by DenmanBC

Thanks to all who replied. I have successfully spent 4 hrs brush hogging and advice regarding start up and switch off RPMs was great. Had a little struggle getting the PTO drive line on cutter attached to tractor PTO shaft. The grooves weren’t lining up perfectly and trying to hold the heavy...

Super helpful advice. Thank-you!

Very helpful. Your assumptions are correct. No clutch on the 3902 HST and no PTO brake. Thanks so much.

Helpful advice. Thanks

Splittable brakes on left. Forward and reverse on right.

Cheers. Thanks for the good advice, particularly the safety stuff.

Thanks for advice but HST has no clutch.

Forum members, Here in coastal BC the ground is now drying enough to allow me to get out on my new L3902 to start brush cutting down the tall grass, broom and vegetation. Since tractor purchase I have mostly been doing FEL and box blade work on dry areas, but now it is time to go into PTO mode...

I was planning 10’

I will try that. Thanks!

Good advice. Thanks

Great advice. Thanks

15-20psi

Not sure if this is the correct forum thread to post questions about tractor shed design but here goes. For my new L3902 and implements I am considering using an existing level 22'x30' concrete pad to build a tractor and implement storage shed with extra space as a workshop. Longer (30") face...

As a follow-up I wanted to post my final decision. In September 2025 I purchased a new L3902 HST with FEL (with additional Piranha tooth bar), rotary cutter, box blade, and pallet forks. Sun/rain canopy and ballast filled R14's + optional grill guard protector. Very happy so far and looking...