Recent content by deltacharlie

I like your way Greg. Much simpler and darn sight less messy! I'll try it and see how it compares before and after. Regards, Dennis

Hi, My hydraulics on the B7100D seem to be getting slower. Before I check the intake filter and change the oil I thought it might be interesting to check the flow rate before and after just in case it isn't a blocked filter. What I had in mind was to disconnect the hydraulic return from the FEL...

My drawing isn't clear and I also looked at Messicks version which is a little clearer. The bushing (oil seal) goes in at the top. At the bottom it is the rubber boot that provides separation and mine had taken on a warp but no way can it touch the propshaft. Try what I did first. Have a look at...

I finally got to the root cause of my squealing. I slid the rubber boot back on the prop shaft and laced it in grease as previous posters have recommended. Tested, squealed like a pig! I then squirted some WD40 at the TOP of the tube nearest to the UJ's where the felt washer (oil seal) is. I...

You are in the right area. I have just jacked my B7100 up on one side so that both wheels on one side are free to rotate. This is dangerous so don't do this. I then started the tractor up, engaged 4wd and top gear. Opened the throttle to mid range till the squealing started. Felt the propshaft...

Hi, Just read your post as I have exactly the same problem. My problem occurred after I fitted a new clutch plate. One year later, I still have the same problem so split the tractor today to see if it was the clutch release bearing. (throw out bearing). It looks OK to me, not rough or dry so I...