Recent content by cuzmarc

Sorry I did not post back here - I was given the run around by the dealer, looks like they just took the pin out and greased it, and put it back as the pin is beat up a bit. They sales guy did come pick up the unit and dropped it back off, even though he dropped the unit off in the middle of my...

Always one in the bunch...

After this happened, I looked over the entire machine and there are a NUMBER of those zerks still in..... I took pics of all of them to prove there was no grease coming out as well as to show the nipple was clearly clogged. They have the unit back as I type this, so I will update everyone once...

I had the same issue with trying to get the grease into that pin after the bolt sheared. It took a small amount then I couldn't get anymore to go in. The dealer called me back yesterday, they did seem concerned and did not question me (probably because i included pictures) and came out and...

Thanks for the response. I already replaced the bolt and fitting and greased it, but the pin still binds and I still hear the noise so I am going to stop tinkering and have words with the dealer. Looking it over a bit more, there are multiple fittings with all of the powder coating still on...

I was all excited to know that the o-ring issue was not a big deal so I went out and was playing around getting used to the backhoe. I was letting my son run the controls for a bit and I notice an orange piece on the ground. Low and behold its a bolt head and for sure from the new unit. I was...

Thanks everyone! I watched a ton of the Messicks videos but apparently I missed that one, or didn't think I needed to watch it.

I am a new owner of a BX23S and for the hour I was able to use it I love it so far. Hopefully this is the correct forum. I was checking it over after that hour, while eating and noticed the ram seal (one to keep the crud off the ram as it goes in and out) on the backhoe was sitting at the eye...