Recent content by Creektrails

Ok, I went out tonight while the temps have been in the low 40's today, cranked her up and hydros worked fine. Still tdon't know the culprit but will start looking for water in the hydro system. I'll get back when I figure it out.

Ok, so i took the numbers off of the kubota filters and since I don't have a Kubota dealer within a pretty good distance I ordered in two filters from NAPA. WRONG size. Where in the operator or Workshop manual does it give the filter number? I guess I'll have to travel to another town for filters

Will pull the drain plug as well tomorrow and check for ice. Thanks

@Dave_eng I didn't realize that there were two pumps. And if they share the filters. (which I ordered two of today and will be in in the morning) then it does seem that the filters may be frozen therefore stopping ALL hydraulics. But if there is that much water in the system that the filters...

Thats about all that I can figure. Why would all of the hydraulics quit? Not even steering. Sounds like somethings frozen in either the pump or the filters. I will know soon enough. The weathers supposed to break Sunday. Looks like I may need a complete fluid and filter change.

Are your hydros completely gone? I just started mine and ran for an hour at 1000 RPM and nothing. Not even steering hydros.

the tractor is a shuttle shift and has 2150 hours on it. The two filters both say that they were changed in 2015 at 1927 hrs. The hydraulic fluid level is actually a little high on the stick and clear as glass. It is 4 wheel drive with kubota loader. I also have a box grader on the three...

THanks, I will gather all the info this am and reply. For now I'm not going to attempt to run her. THere should be a warm up next week and she ran good in the warmer weather.

Hi, I'm new to Kubota, bought a used M7040 2008 this summer. Shuttle shift. Was going to move some cut timber today with the front loader at 15 degrees outside. It's not gotten above 30 for about 2 weeks here. Tractor started great but none of the Hydraulics work. I let it warm for 30...