Recent content by Cree Dog

Dave, I pulled the couplings off and this is what I found. See Pic. I replaced this piece and the female piece and the 3pt went up and down several times and then just stopped. Disconnected the NEW couplings and found this same thing. As you can see the nipple in the middle is off to one side...

That lever is also in place and properly adjusted The feedback rod is in place. I will check the adjustment this morning.

The loader valve stays with the FEL. I have the bypass hose in its proper place as it has not changed in 16 years when I remove the FEL. I had raised one time after the tractor was restarted then it sounded like the valve that allowed fluid to go to the 3pt did not release but, it is on a handle...

I have a 2001 BX2200 that I have owned for 16 years. The 3pt will not raise and it sounds like the hydraulics are not disengaging when the 3pt reaches the top of its travel as it is supposed to. Obviously the mower deck also dose not raise. It will move forward and backward, just the 3pt and...

The purchased u-joint cross was 2.007mm in length and the original u-joint cross was 1.966mm. I used a Bridgeport Mill and shaved off 0.5mm on each end of the u-joint cross. The Caps had to be pushed a little farther into the yoke so that the C-clips could be inserted properly. I've used the...

I have an update: I purchased the U-joint that I stated I would and I attempted to install it this weekend. I ran in to an issue. The Cross of the u-joint was too large to fit between the yokes. The caps fit perfectly. I needed to modify the length of the u-joint cross so that it would fit...

The exact measurements are as follows: - cap dimensions - 20mm/0.7875" - from the top of one c-clip to the top of the other directly across from it - 38mm/1.465" - Overall length with caps installed - 53.65mm/2.112" Here is the exact part on the look-up part of their web site. (Link...

Thanks to all of you for your advice. I ended up finding the exact replacement for these on summitracing.com supplied through an after market company called GMB. You can go directly to GMB.net and follow the drop down boxes select the measurements and the type of u-joint you need and that part...

I have a 2001 BX2200 with over 2.4K hours on it. Recently I had a front u-joint go out, the rear of the 2, there are 2 of them. I do not want to purchase the whole assembly, does anyone know where one can purchase just the u-joint? The local dealers where I live want $85+shipping for the...