Recent content by Clyde Smith

Changed out the hydraulic cylinders to the 1.5" cylinders and got the fittings so all is good

It is my father in laws tractor and it has been like this since I started working on it . I have got everything working but the rear lift so far. It acts like it's jambed some how.

Oh yes I have made sure it's clear of any obstruction

Lift handle stuck doesn't want to move freely

My mistake they are closer to 3/4" pin holes

Got the magister cylinders today they are not quite what I expected the pin holes are larger along with the shaft end being narrow and the fittings is another problem

Yes with a pipe wrench I do not have the spanner wrench or a large vice to remove the cap

I loosened both white still attached to the loader

They are for the LA302 BUCKET

Yes have a fed-ex tracking #

I had already taken the 2 bucket cylinders off and was going to put seal kits in them after unscrewing the cap on one of them and setting it on the table as I started replacing the seals on the head I picked up the cap to replace the seals and it fell in 2 pieces

Has anyone ever had a cap on a hydraulic cylinder cap break before

Thanks for the help I ordered a pair of cylinders hope they fit so I can get this kubota working for my father in law he's 82 and really likes this little tractor

I know the kubota hose fittings are metric do you know what fittings will be needed to install these cylinders