Recent content by ChiefKubby

  1. C

    looking for some help, trying to find a bucket for my BH70 backhoe

    Thanks, I now have a good idea of where to look. You would think Kubota would sell a finishing bucket
  2. C

    looking for some help, trying to find a bucket for my BH70 backhoe

    looking for some help, trying to find a bucket for my BH70 backhoe. I'm looking for a bucket without teeth, similar to a mud bucket but with a similar width of my current bucket. Any advice as to who would sell something like that?
  3. C

    Question about installing a sub frame on my L3301 with a 4672A backhoe already mounted to the tractor

    I finally found someone at the local Kubota dealership that knows whether or not the sub-frame for my L3301 would fit my B4672A. Backhoe. It DOES NOT even come close to fitting. So I will post my B4672A for sale and look for or order a new BH77 backhoe. There is a 3-4 month wait for the BH77 so...
  4. C

    For Sale B2672 60" Snow Blade

    Would this fit/work on a L3301?
  5. C

    Question about installing a sub frame on my L3301 with a 4672A backhoe already mounted to the tractor

    Thanks for all your advice, I have to do more investigation. I wish I knew for certain that the sub frame would fit the 4672 backhoe.
  6. C

    Question about installing a sub frame on my L3301 with a 4672A backhoe already mounted to the tractor

    Yes I wanted to know if I needed to stiffen the frame becasue of the size of the backhoe or is the set up I have OK? I called a couple of Kubota dealers including Messicks and they were not sure if the backhoe would get in the way of the subframe.
  7. C

    Question about installing a sub frame on my L3301 with a 4672A backhoe already mounted to the tractor

    I have the 2 bottom lower links of the 3 point hitch attached to the backhoe(4672) and the top link is the rectangle shaped orange bar, see attached pictures. Because the Top Link is locked in with two pins, I locked Float Control, so I do not raise or lower the backhoe. A lot of the comments on...
  8. C

    Question about installing a sub frame on my L3301 with a 4672A backhoe already mounted to the tractor

    I am considered about the support on my frame for my L3301 with a 4672A backhoe (which has it's own hydraulic reservoir and only use the rear PTO) that is currently attached. I would feel more comfortable knowing that if I installed the support frame, it would eliminate any frame bending...