Recent content by Chaos2art

Thanks Wolfman - Still floppy. Darn

Thanks, I am heading out of town to volunteer teach for a week. Waiting on Wolfman and working on my RM550 as well.

Two pictures showing the feedback bar with one spring and cotter pin temporarily replacing roll pins.

I'll try to get a short video and post it. Probably Monday. Thanks.

I am not sure figure 40 is connected to figure 10 (the blue circled area.) Should I be able to see the blue area without have to take the case apart? I'll have to see if I can figure that out when it quits raining. (Tractor is parked in the mosquito playground.) Thanks,

Rain again, too bad it didn't come in early July. Hay is $4 a bale more expensive than last year. I have the pins coming ($15 shipping for a $2 part, but I am getting use to it. ) Right now there is a substitute cotter pin in place. NONE OF THE 3 PT HITCH OR BELLY MOWER MOVES THE CONTROL ARM...

I was able to remove the pins and replace them with a cotter pin. I removed the extra spring. NO CHANGE AT ALL. Does that mean I'm tearing the linkage apart and looking for a pump or something? Please any other ideas?

I could not push the pin back in I but was able to remove the pins and replace them with a cotter pin. I removed the extra spring. NO CHANGE AT ALL. Does that mean I'm tearing the linkage apart and looking for a pump or something? Please any other ideas?

I was able to remove the pins and replace them with a cotter pin. I removed the extra spring. NO CHANGE AT ALL. Does that mean I'm tearing the linkage apart and looking for a pump or something? Please any other ideas?

Thank you so much. Since my pin is horizontal I get the idea that it is sheared off and I will have to drive it out. My Irwin punches aren't metric and I get the impression the measurement must be exact, so thanks for the picture of the pin punches. I will purchase those as well. My next step as...

Since it is pouring rain I crack the manuals again and see if I can figure out the holes you gentlemen are talking about.

Thank you Thanks so much for guiding me on where to look next. I hopefully understand the pin situation, what is the red circled area representing?

Dan, I just posted these to Wolfman. I also wanted them to get to you. What other pictures do you need? " Sorry for the delay - Nothing is attached to pin 50/150. The feedback moves and turns the 40 bracket, but alas......nothing. Can you help me with what I am missing? I tried to push the pin...

Sorry for the delay - Nothing is attached to pin 50/150. The feedback moves and turns the 40 bracket, but alas......nothing. Can you help me with what I am missing? I tried to push the pin in with a piece of wood and it didn't move. Is it all the way in? Do you know what my next step would be...

Thanks Wolfman, I have this diagram, I have every diagram, but couldn't find rollers. Let me do more research.