CdnSldr.ret's latest activity
-
CCdnSldr.ret replied to the thread Issues with loader dump after overpressure/blown line L5460.A rather anticlimactic end to this thread! Kubota diagnosed the issue as being with the male QC for the dump cylinder rod end. They...
-
CCdnSldr.ret replied to the thread Issues with loader dump after overpressure/blown line L5460.It has been a few years since I’ve had to read hydraulic schematics, but the load check operates in the return circuit does it not...
-
CCdnSldr.ret replied to the thread Issues with loader dump after overpressure/blown line L5460.For completeness for anyone else viewing this thread in the future, this is the location of the load check valve.
-
-
CCdnSldr.ret reacted to TheOldHokie's post in the thread Issues with loader dump after overpressure/blown line L5460 with
Like.
Yes, I looked at that yesterday. As I suggested remove and inspect it. Its just a one way poppet. Unfortunately, if its damaged... -
CCdnSldr.ret replied to the thread Issues with loader dump after overpressure/blown line L5460.I was able to find the hydraulic schematics in the service manual. I’m convinced the issue is with the load check valve not fully operating.
-
-
CCdnSldr.ret replied to the thread Issues with loader dump after overpressure/blown line L5460.This might be one for the dealer to figure out. Well worth the $250 insurance deductible. Either way, thanks for your effort on this.
-
CCdnSldr.ret replied to the thread Issues with loader dump after overpressure/blown line L5460.In my searching I found this video that talks about a broken check valve wedge that affects curl/dump. Any thoughts on that?
-
CCdnSldr.ret reacted to TheOldHokie's post in the thread Issues with loader dump after overpressure/blown line L5460 with Like.
In regen both ports get connected to full pump pressure and each other. The force diifferential across the piston displaces the rod...
-
CCdnSldr.ret replied to the thread Issues with loader dump after overpressure/blown line L5460.In regen there is return oil from the rod end to the spool then it gets diverted to the piston end. Yes flow is supplied to both sides...
-
CCdnSldr.ret replied to the thread Issues with loader dump after overpressure/blown line L5460.I re did the test forcing the rod end fluid through the QC. Same as last test. The QC appears to be fine. A messy test, as the first...
-
CCdnSldr.ret replied to the thread Issues with loader dump after overpressure/blown line L5460.Curl supply (rod end) is blocked at the male QC that is disconnected, but no it doesn’t,
-
CCdnSldr.ret replied to the thread Issues with loader dump after overpressure/blown line L5460.Re doing that test with the bucket on the ground, the bucket dumps in both positions and fluid drains from the rod end hose when...
-
CCdnSldr.ret replied to the thread Issues with loader dump after overpressure/blown line L5460.After disconnecting the female end of the QC on the rod side, the bucket fully droops when the loader is raised and dumps all of the...
-
CCdnSldr.ret replied to the thread Issues with loader dump after overpressure/blown line L5460.My bad on that, I thought first position was standard power dump and 2nd was regenerative dump. Will try that when I get home.
-
CCdnSldr.ret replied to the thread Issues with loader dump after overpressure/blown line L5460.I thought I did that in the original post but here’s more detail. 1. bucket curl and all other functions (except dump) appear to...
