Recent content by cavjock23

I love my forks........ Can’t beat using to lift metal rafters and purlins....

Sir Any chance you could provide dimensions? I’m thinking I’ll go this route,, My tractor is 4 hrs away from my mig welder..

That is sharp.... Awesome job.... Maybe a project for me this christmas...

Surely somebody has done this...

How do you fold your guard forward to open your hood? By the way.. That looks awesome

i would look for conveyor belting. Also, you can buy replacement belting designed for guards at dealer.

Messicks has it.. Same thing happened too me. I haven’t bought it though..It was stupid pricey..

Yes the factory location is a joke. The door will not open all the way. It hits the loader linkage. It’s also susceptible to damage being so low.. It is behind the left tire..

You will love the M6060.. I pulled a 7 footer pull style with no problems. (it’s for sale if your interested) Now pulling a 10 footer bushhog. It did bog down in hood high grass going about 4.5 MPH, but normally i’m shredding weeds and brush. It handles my normal stuff very easily. Can’t go...

Has anybody moved the toolbox? Thinking side of loader bracket... Ideas..

John Deere's heavy duty model. 7 foot cut width. If you can run it over with tractor, shredder will eat. Gear box oil is clean and never has leaked. Hyd cylinder recently re-built. No rust/No cracks. Blades show no wear (40 hrs on them since installed). Laminated Tires in good condition. Will...

Picked this up too use behind my M6060.. The tractor handled her very well.. The shredder needed a few hrs of TLC.. Fresh gear oil and fresh grease for all the joints. Now need to unload my 7’ deere cutter.. Ill list it in the classified section for those interested. Curious, any 3210...

Yes.. front hub off kubota M6060.. 2wd...

It was real bad.. I had to weld nuts to back out the old studs..

I failed to check lug nuts and my front tire became loose.. Ran a bit and tore the original studs up..