Captain13's latest activity
-
Cand on that note of disconnecting batteries, those of you who own or service the DEF-equipped tractors, if you for some reason...
-
CCaptain13 reacted to bucktail's post in the thread using tractor to pull a stuck car/truck/rv with
Like.
The drawbar in the rear. I assume that the fork ront is on a loader. You can tweak the loader pretty easily if you aren't careful. -
Cmy very first tractor job was a first service on a Deere small tractor. I had never been around tractors much so it was quite daunting...
-
CAt 50hrs mine on the M62 were a bit out of torque range. At 70hrs the M7060 had most of the rear lugs out of torque. Both were good at...
-
CCaptain13 replied to the thread B7800 Wix or Fram filter numbers for oil and hydraulic filters..I realize that millions of people have used Frams for many years. I used them for several years on my first cars. Then I went to work...
-
CGood job guys! Just did 3 of mine. Well....replaced boards on the 12 footer and added flooring to a couple of small trailers that had...
-
CCaptain13 replied to the thread New decking on my trailer.Not sure if you are going to seal your deck, but I found a sealer that really penetrates the wood, is not paraffin based (Thompson‘s...
-
CCaptain13 replied to the thread Leveling rear blade.Are your lift links right and left attached to the same holes in the lift arms. There are two holes on the arms. Make sure you are...
-
CLower the adjustable arm to make the blade sit level. an inch or two at the arm will add more drop at the very end of the blade. Seems...
-
CCaptain13 replied to the thread Leveling rear blade.I said that because the op said that in his original post. I should have said “If there is no adjustment”. Glad you have tilt.
-
CCaptain13 replied to the thread B7800 Wix or Fram filter numbers for oil and hydraulic filters..Sorry I didn’t say more than “Don’t put a Fram on that tractor.” I have a Ram with the Cummins diesel. The first one I bought was in...
-
CCaptain13 replied to the thread Leveling rear blade.Something I would recommend before leveling your lift arms is to try to find a hill steep enough that you can lower your blade and it...
-
CJust like for any implement on 3ph: use the right side adjustment to adjust the height the right side is at.
-
CCaptain13 replied to the thread Kubota SVL75 Skid Steer IS Blowing White Smoke.If the smoke has a strong diesel smell, it’s probably unburned fuel. That can be due to low compression, low cylinder temps, and...
-
CCaptain13 replied to the thread Question(s) about tending a brush pile fire with the tractor..it did look like that. Except with less paint.