Recent content by cabbott

Thanks for the reply. This gives me a starting point to trouble shoot my problem. This is the first complete schematic I've seen on safety circuit. I will verify that my tractor is wired the same way. Again Thank you for providing schematic.

I do not have the seat switch bypassed. It works like normal. I will look and see if it is 2 wire or 4 wire. I think it is the 4 wire but will check to be sure. Thanks for all the reply's.

Thanks for the reply. Still looking for a complete wiring diagram of safety circuit. All micro switches in safety circuit or good when checked with ohm meter. The OPC relay has a timer associated with it and I would like to know just how it is wired so I can trouble shoot it. Thanks Cabbott

Thanks for all comments. I will try and clarify all the above comments. The tractor runs fine with the PTO and F/R shift selector safety micro switches bypass, ie. shorted out. I disconnected the cables to micro switches and put jumpers in the connectors. This model tractor MX 5000D does have a...

All micro switches for safety circuits have been checked and they are OK. I have bypassed/jumper out the shift selector and PTO circuits and tractor will run as normal. I think there is a timed relay in this circuit that is bad. I do not know were the relays are located or how the wiring is run...

I have a MX5000D that has electrical problem with safety circuits. When I move the shift selector from neutral to forward or reverse the engine shuts off. Also the same with PTO selector is moved to engage. I currently have both safety circuits bypassed so I can utilize the tractor. My question...