Recent content by C-Ranch

Just wanted to give an update and thank you for the contact info. I ended up calling Ag Express and out of all the people I spoke with, they were on top of things and new exactly what I needed. Ten days after speaking with them I was up and running. I would recommend these guys to anyone needing...

Thank you for the info! If the guy guy coming to look at it can't do it I will certainly reach out to them. 👍

Lack of water here is going to make for a tough hay season as well. First crop done and water is back on, but will be lucky if still have water come end of July. Sounds like your round baler is basically new. I looked at a JD round baler and was impressed, but the place I had bought a few...

Well I hope and pray the cable never gets worn through or chewed through, but liable to happen. I did look on the inside and underneath where the wire is routed through, but wasn't luck enough to have a roll tucked & tied up anywhere. Hopefully the wiring tech guy can get me hooked up before to...

Tx Jim If your round baler (looks like a JD) is still rolling rounds I certainly wouldn't change it out till you absolutely had to. As for making a 5x4, 5x5 or 5x6 it's a simple adjustment on the monitor along with changing bale density adjustments....I apologize...I meant 5x6 not 6x7 on my...

Dustyx2 I am very disappointed on the dealership service end. Most just simply don't try or look in the parts book and don't see what's needed and say it can't be done. I was more disappointed when I contacted Kubota tech support directly and was told nothing was available and was told to look...

Dan, You and I must think alike. Spoke with a gentleman this morning who does wiring for all sorts of automation equipment. He said the pins and can connectors are easy to assemble with the right tools. He's going to swing by next week and look at the connectors and the wiring diagram I have...

Cut and splice is the easy option however the monitor may not work correctly as the voltage changes across all the sensors these new balers have on them. I did this on another baler a few years back only to find some of the sensors gave a wrong single. So figured bad changed sensor. Put in new...

The M5-111 will pull it but you can feel the baler behind you and in a thick crop it will pull it down if your going over 3.5mph. When on flat average crop like grass it does fine, but can still tell it's working behind you. If I do a 5x5 bale weighing 900lbs no issues. Make a 6x7 bale 1500-1600...

I currently have a round baler (BV4580) that I pull with an M5-111. However, that works the tractor pretty good, so decided to hook the baler to our Case 7120 Magnum. Everything hooked up just fine until it came to the two cables that need to go into the cab of the tractor. One is power and the...