Recent content by BX2680MR

A year ago when I bought my 2018 BX2680 it had 350 hrs on it. Now in just shy of a year its at 465

Polaris is next.

And the new tilt and swivel, finally, three weeks later everything works.

Found 'em

Of course, but with the shaft clipped onto the pto its nowhere near the spline on the snowblower. I'll likely just take it to the machine shop and have them extend it to the proper length. Itll cost another couple hundred dollars and turn it into a $700 pto shaft. But atleast itll drive this...

MR is my initials.

Its 33". Sittin here looking at this french owners manual and when i gave this part number thats listed in the manual to the parts woman at the kubota dealer I made sure to ask the length and she said its also like 38" or somethin like that, not 48 anyway, which is what the measuring tape...

So I ordered the wrong PTO drive shaft for my BX2750B snowblower thats mounted on a BX2751. Its about 15" too short. Before I order the wrong one again would someone have an idea the part # for the proper one. One thing that stands out is where it says "SERIAL NO. 2410735 AND UP" Im wondering if...

And then I climb under there to install this new $500 pto shaft fresh outta the box, and it's too short... just battling here and not getting very far

Thanks for all the replies. The only real definite reply tho was the one saying that my only two options are to get rid of that bank quick attach and just swap all couplers or buy a quick mount coupler for the snowblower. The rest seemed like "try this, try that"...

Could someone please give me a part # for these hydraulic fittings on this bank. I went to kubota dealer and they can't seem to find them. I need to change the fittings on hydraulic hoses for snowblower so that I can hook them up to that bank or manifold on the tractor. Thanks

Ive narrowed it down to just a couple wires i need to tie into accessory power. Theyve even got the tie in ends on them. Just not sure which of these 4 wires coming off the ignition I tie into for accessory power when the keys on. The ground wire will go to the battery, these other two with the...

Hi, This spring I bought a 2018 BX2680 with the 3rd set of hydraulics and switch on the joystick for the grapple. So just yesterday I bought an older BX2750B snowblower. It uses the older attachment with the driveshaft rather than the yolk. Anyway, everything lines up and works but Im sitting...