Recent content by bx2380

Direct cross ref. Is Baldwin B7285 20psi anti drain back. The others are a B1400, B1402 and B1402. All with a 14 psi drain back valve. Be careful with some filters cross ref. If the thread, gasket and can are the same they will cross it. But may not meet mfg. specs. There are different paper...

FOUND IT WITH YOUR HELP! I got my tractor back Thursday and ran it a couple of hours with NO issue, Got ready to load it last night to finish a little project at church today. And it did it again! So I did as you suggested with the key in the start position worked the PTO lever, then the HST...

When a repair is the expensive the dealer normally will get the MFG involved before going very deep. That way if it is denied they are not on the hook for the repair if the customer is not willing to pay. Back in 79 when IH went to unleaded and the 4V carb on the Scouts w/345 they would make...

Same Cole Hersee switch. Only for some reason Kubota didn't use the dust boot. I will say from what my dealer tells me (I was raised in an IH AG and Truck Dealership) And have know the owner and salesman for many many years and trust 100%. But I mine is the only Kommader user that uses the...

Thanks for the tip! I will try that and let you know!

I has done it both on and off the seat. Not touching pedals. I'm sure it's most likely a safety switch hanging of some kind. Or a faulty ignition switch. But for now we have to play by the rules Kubota will allow them to change. A time or two I have smacked the right side of the dash that...

I have a BX2380 with just shy of 200 Hours on it. I took delivery in late March early April of 2017. Since about 2 weeks of owning the tractor I have had a starting issue. It has been hit a miss and it won't do it at the dealer or long enough to properly diagnose the problem. Every now and...