Recent content by Bucksnbratz

I'm trying to remove the water separator sensor plug on my tractor and I'm not having any luck getting it off. I've pushed the small tab down to try and separate the plug, but I cannot get it to budge. Any suggestions on how I can get it separated without damaging the plug?

According to what I saw in the manual, the width is 84 and weight is a 1000. The cutter exceeds the weight by 47 lbs. I usually cut with the FEL.

Being new to tractors I wanted to make sure I wasn't exceeding the capabilites of my tractor. I mainly cut pasture, small saplings on some uneven ground. I don't usually cut too fast to start with. I do have a pretty good hill that I cut as well. Looks like this cutter is about 300 lbs heavier...

Thank you for your response. Mainly cutting pasture and want something to go out past the tires. The cutter is about 300# heavier, so I just wanted to get some input. Thanks again.

I currently have an mx5400 with an RCF 2072 brush cutter. I'd like to get a wider brush cutter, so I'm looking at the RCF 2084 for that reason. Brush cutter is heavier, but I think the Mx 5400 can handle it or is it too much for my tractor? I'm not seeing it listed as a compatible implement in...