Recent content by Buck8one2

Does it do this in L-M-H range? Buck

I had my B7800 all of 5 minutes when I tried to pull it into the garage and heard this awful crashing sound. Yup, roll bar ripped the garage door completely off the tracks. To this day I am always looking up to make sure of the clearance incase the door isn't all the way up. Buck :oops:

NIW I discovered in my problem with this issue that there are 2 versions of the wiring harness. On my machine and the wiring diagram the shows the white wire from the from the relay splits and goes goes to both sides of the solenoid ( hope that made sense ). In fact from the relay connector...

When I first got my B7800 and before I had the chance to check everything out I had a similar problem that you describe. Mine would just stop running and choke to a stop, then start up a few minutes later and run fine until it stopped again. Turned out to be a very dirty fuel filter even though...

Try Summit Racing, they have A LOT of different types. Tubing, slit side, Velcro closure, heat resistant, fire proof....on and on. I bought some to cover the lines for a grapple. Buck

Well we finally got the B7800 running. Short story, rat eating insulation, rat builds nest on top of wires, nest packs bare wires down and shorts out relay, stop solenoid, and controller. Replaced all and still cranks but will not fire, yet all switches and lights work and still no click from...

I did that once, tractor running sluggish, mowed half the yard before I noticed the parking brake was on. Sheesse felt like dummy.

Check out Long Equipment. I bought a beyond valve for a grapple. It came as a kit for the B7800 with 402 loader.

They gave me the number, they never asked about SN or age of the tractor. I gave them the model (B7800) with mid point pto and about the damaged wires to these 3 items and I wanted to order the stop solenoid, the start relay and controller. They came in and the solenoid and relay were correct...

GACK.....my apologies to all! I just went back and took another look at drawing B10102 and it does does list the correct 6C190 part number. Must have been seeing too much red and snorting fire at the time. I still wonder why dealers don't know of this. Its in the details I guess. Thanks...

Thanks RCW Yes I have seen this one. If you look at drawing B10101 (switch mid pto type) and B10102 (switch mid pto type) on that same page it explodes the view and list part numbers. The diagram shows controllers with pigtails and the K3511 part number.

Thanks Henro My WSM file listed as B2710 B2910 B7800, note it does not list the B2410. Without comparing page by page both are the same. The wiring diagram is identical and the picture diagram on the very last page shows the controller with the pigtail. which my controller has no pigtail...

Thanks Wolfman That would explain it, but surely there would be schematics or information for it somewhere?

Thanks for the reply RCW To answer your questions: 1 no smoke no fuel 2 2 weeks 3 3weeks 4 yes 5 clear 6 yes 7 not in garage I checked fuel and air to begin with then noticed no click from the stop solenoid checked for power at connector...none. Pulled dash and found nest and eaten...

This is my first post, and have read a bazillion threads regarding any issues I've had with my B7800. First I want to thank everyone for taking the time to respond to all the questions that seem simple but not so simple to solve. I've been searching the forum about everything concerning the...