Recent content by Bryson Lamboy

Thank you very much, I’ll keep you updated.

Yes I replaced with a new pack and all seals. I tested the clutch pack by blowing air into the port and I can see the pack engage and release when air is applied. I'm thinking the clutch pack is okay and i am not getting enough pressure to and through the valve assembly. I do not have a service...

I replaced filter and fluid with Kubota products and still no difference in fluid pressure. I'm not sure what direction the fluid flows in the gst valve assembly from the pump. If anyone has a diagram, that would help. Thanks

I checked my pressure readings Pump 360 Pilot pressure 300 Gst 300 Clutch pack 100 Modulate valve 75 These are still with the traveler fluid, I haven’t got the udt yet. I’m wondering with the udt fluid will I have more clutch pack pressure.

I still don’t understand why I have no clutch pack pressure. I check the port on the side of the gst valve assembly, all my other pressures are good except the clutch pack which I think is why it is not pulling in high gear.

I have replaced the entire clutch pack, and the manual clutch. I do not have a WSM and I am running a wix filter and traveller brand hydraulic fluid. Inside the gst valve assembly I found a stuck valve so I cleaned it up but still not working. It seems like pressure is leaking from somewhere.

I have an Kubota L4200 gst 4x4 rops. I have been to multiple dealerships and no one can help me. My tractor is loosing power under a load even driving up a slight grade in high gear. I notice it more in higher gears especially driving up hills. I have replaced the clutch and pressure plate, and...