Recent content by bryonh

On a bx2680 there is obvious knockouts for 3 switches see pic. I have googled and looked trhough parts diagrams with no luck. These would be a 3/4” square switch. Im adding lights to my ROPS and want to have nice clean factory look to panel. Looking for ip67 type rocker switch thats dust and...

I'm looking for a full Parts Manual for my BX2680, I found some sources for other models but can't find this specific model. Anyone have suggestions. My dealer didn't even have one, he was using Kubotas online access for dealers. I guess he would have to print out every page one at a time...

ok so mine is fixed. there are two "seat" switches and its confusing because in the parts description they both say seat switch. The One pictured in this thread by another user is actually the tip-over switch, it is actually in the hinge are of the seat driver's left hand if behind the...

mine turned out to be the actual seat switch. I finally got out of the weather enough to test it properly. I did get the turn-over seat switch replaced and then removed the actual seat connector and jumped it and tested it and the engine dies about 1 sec after engaging HST if that harness...

i got it! thanks

thanks! good info to troubleshoot this.

I purchased a kubota bx2680 last year and fix most things myself and I am looking for a wiring diagram, Im hoping I can get from dealer, but i haven’t been over impressed with their knowledge about options like light kits or block heater option etc have any of you found a differnt way to get...

Dave, this is exactly what is happening on my bx2680. there is a delay for engine stall when pressing the hst pedal, I suspected the OPC system as you mention here. question: when you say " If you disconnect its wire, then the various safety devices cannot stop the engine as I am suggesting...

did you figure out your problem? I have the same issue on the same bx2680 model. I inadvertently shorted the seat relay down at the seat hinge which blew the 15 OPC fuse, the engine died, restarted it and fwd/rev worked, got done and the key wouldn't turn off the engine. so I replaced the 10a...