Recent content by Brinet

What about taping the broken pieces back together (from the back side). Then coat in fiberglass using the original as a mold? You could even get creative and tint the resin.

Correction. Oil is delivered TO the HST AFTER the oil filter through an INTERNAL port/tube/line (whatever you want to call it). How does it return to the resivoir? Two options from the WSM. Will either path be large enough to pass metal fragments? Watching to see the HST replacement outcome.

The hydrostat assembly in the BX is bolted to the front of the transaxle. The screen filter for the fluid is in the bottom of the transaxle reservoir. Unless the pieces you found in the screen are small, I would more suspect transaxle issues than hydrostat. there are only 2 hydraulic return...

I have a BX2200 with loader and have no problems changing the oil. There should be no lines near the oil plug. Also, I am able to remove the oil filter by hand with the loader attached and side panels on. I do not have small hands. Make sure to oil the gasket on the new filter before...

i received an engine for a project. When attempting to turn it over for the first time, it stopped hard. Turns out it got damaged in shipping and a chip of the intake manifold flange broke off, fell down and wedged between the intake valve and head on cylinder #3. Very low compression on this...

In both of your pictures, nothing is connected to the “lift arms”. The “lift rods” are connected to the frame at the top. I’m assuming they are connected to the “lower link“ on the bottom. From your pictures, it also appears the lift arms were down at first, and then raised. However, your...

I believe this engine was used in the Kubota T1600 riding mower.

Just order it from the dealer. They are still available. I recently ordered one for my 2000 BX2200.

Soloved, I'm not far from you in WNC and may be able to help. Send me a message with contact info if you need assistance or guidance.

The axle bolt passes through the housing. Over time, the bushing and o-rings wear out. Replace both. I would suggest replacing the (very expensive) bolt also. Bushings are hard to remove. One trick is to tap the bushing using a 3/4" pipe tap. Screw a 3/4" piece of pipe in and drive the...

The 20 watt D.C. 12-24 volt are what you are looking for.

I think these are the floodlights I purchased. Led lights I don't have an install picture, but these are almost a perfect fit when mounted behind the steel cutout for the original housings.

Can you explain why the warranty would be compromised? It doesn't sound like any holes were drilled or any structural modification was done.

I resolved the dim bulb issue a different way. There are LED floodlights on eBay that are an almost perfect fit to the factory. I removed the factory housings and added 20w 12v LED warm white floodlights in the same location. Almost blinding difference!! I purchased a 5 pack for future needs...