Recent content by BiPolarBear

Got it sorted. I had to remove the stopper under the foot rest. Thanks for all the help

Yeah that’s what I’m thinking too but there is a stopper under the foot rest that is preventing it from going further back I might just modify or remove it and see how it goes. Ta

looks a lot better than the rust bucket it used to haha.

I finally got the clutch in and it all back together and painted. I used rust oleum safety orange thinned out for my cheap hvlp spray gun if anyone is interested. I’m happy with the results. I am having an issue with the clutch pedal/ adjustment The pedal is wedged between the clutch linkage and...

Possibly it’s a freeze plug to allow for heat expansion and to avoid cracking. I measured 12mm hole with no threads. I’ll see if my local supplier can get me a plug. on a positive note I found an after market supplier of clutches in Australia called BareCo. Got the entire clutch kit for...

The only drawing I could find doesn’t have it labeled. I believe that it may be casted for a part in the transmission but only guessing. It’s a little below the level of the trans fluid so it must be meant to be blocked. I just don’t know if it will effect anything on the transmission off o put...

It looks like it is meant to be plugger looking at the screenshot from the above video. I’ll thread lock a bolt in there I think and see how I go.

I drained the fluids and I have the tractor split. Had to remove the bucket and take one half of the loader Frame off to do it. The seals looked fine so I decided to refill the transmission only to find it is leaking from a hole in the transmission. See pictures below. Not sure if it’s a...

Yep I’ve got the fluid drained and the front axel held still. The hyraulic hardlines are loose but they will not fit through the small gap between the loader mounts and engine. I will send a photo when I get time to show you what I mean Id be done by now if there wasn’tfor the loader being in...

Started the tractor split today.
The front end loader is going to cause massive dramas. Does anyone know if there are any detailed threads on doing this job or a clutch replacement? 
The loader chassis/ support runs all the was to the rear where it's bolted to the ROPS/ axle. I had to plasma cut...

Im hoping there is a chance I could source a seal locally using the part number from the below pics? See below for front view of trans and seal below.

Yeah I got my light and mirror in there yesterday and all the oil was down low but very hard to judge through the inspection hole because of the clutch parts and the prop shaft Case. Looking at a picture I found the only place is the seal+ o ring. This video shows it in the first 5 minutes. . He...

Just so I’m positive can someone point out the fill level and fill point on the transmission? The Manuals arent helpful. But I filled it up using the cap behind the shifters and filled to the highlighted bolt from memory. But I’m starting to think it maybe the wrong bolt 😑 See diagram below...

Also I cannot seem to find a seal locally, at least online anyway. I’m not sure if messicks ship internationally but they are cheap in the states. I can only find a single stage clutch locally also :/ I’ll try my kubota dealer next week otherwise I’ll have to pay import tax and shipping from...