Recent content by Biologist MYoung

Another update. Still havent gotten the speed control to move. I am apprehensive to take the valve body off to remove it. I have; however discovered I am building pressure at the hydraulic fill port. Not a scary amount but enough to hear a "psshh" when I remove the cap. Is this normal or could I...

Update... Maybe the speed control valve. It seems to be sticking and I cant get it to move open or closed direction. Also the lift handle doesnt work consultant. Daft lever still seems to be working correctly but not the lift side

Been having trouble with 3pt "looking prime" recently. Have to loosen remotes to get fluid to flow then tighten back. Now after doing that, the 3 pt wont lower and it doesnt seem to be the speed control valve under seat. Seems to be getting air in system because even the loader is "bouncey"...

Yes but did actually find one taped under a large section of wiring harness. No mention of this fuse anywhere in manuals or anywhere else. The only way you could find it is by begining to remove the complete wiring harness and yes, it was the issue.

The only thing I see after scrolling through readout is T24280L (I dont think is a code). When the Eng NG is up, no other numbers arr shown

I figured as much. I just need to figure out why

Not a regen issue but thanks for trying. I have had employees ignore regen and even in level 3 and 4 they would start up. The only thing I have found is fuel pump not coming on but haven't figured out why. Something in the ECU isnt powering up

Update. It is the code Eng NG not the all caps ENG NG code I originally posted. Manual indicates engine comm issue rather than ECU comm. Not sure if that helps me but that is where I am with it.

Looked for damaged wires with no luck. No other codes unfortunately. The ECU did "buzz" for just a second once when reconnecting the battery. The only thing that doesn't "seem" to be working is the fuel pump. All the dealers near me are backed up and short handed and will be over a week before I...

M9960 wont start. Cranks but throwing an ENG NG code. Fuel pump not coming on. Research indicate an ECU communication issue. Is there a scan tool I can purchase to help other than the kubota diagmaster?

I have a problem with the lift arms and remotes not working sporadically. Sometimes after starting the tractor it may take 15-30minutes before they respond. Usually after they start, they work fine the rest of the day. Fluid and filters are good and loader lifts up and down fine all the time...