Recent content by BillyBX

Dan, which line is the "Power Beyond" ???

By the way, which line is the Power Beyond ??? I'll start with that one . . . . . . Thanks guys! Billy

Dan, I purchased the new lines/hose from Messicks and said the couplers had been replaced with new ones and that's the ones I got. I had to get both the male and female coupler parts to go to the new part. AND I agree with taking the couplers out of the mix. I never disconnect the FEL. Russ...

Hey Dan, sorry its not easy to follow. So I only need A,B, C and use themcat valve and pipes?? ?? ?? Not sure I follow . . . . . Everything is hooked up exactly like the diagram attached. Going to replace the new lines & quick couplers one at a time with the old ones and see what happens. This...

Pic 1 is the control valve from the top down. #1 and #2 go to the right side lift arm (see pic 4) Pic 2 back side of control valve where lines go thru the frame. Z goes to right side lower port. V goes to left side lower port. X goes to right side middle port (see pic 1) Pic 3 X goes to...

Good morning to all of you "Tractor Buddies!" As per request, I will take pics with labels of all lines/hoses I replaced as well as fittings. Then will take pics of control valve and where each line/hose goes. It is exactly the same as before servicing but will post pics to help with...

All three lines do go to the control valve. They are plumbed and hooked up exactly as in the diagram. I used the same diagram but also my pics with labels confirmed every hose is exactly where it was prior to servicing. Now I did observe that one of the new quick disconnects to the valve body...

Lol :) I mentioned it yesterday in a post at 4:19 pm. ! So here's some pics of the lines (hoses) in the pic #1 and #2 are lines/hoses and fittings I replaced. They are all totally in the correct ports as I've now triple checked them with pics, labels and diagrams. The 2nd pic shows another...

Everything worked fine before servicing it with a couple new lines, connectors and fluid & filter change. Did not adjust or mess with anything else . . . . . . :(

I will re-verify! I took pics and labeled everything so I would like to think I got it correct, BUT who knows! I will complete this task and get back to all of you here! Thanks :)

Dan, I disconnected and reconnected the quick connectors . . . . . . . no change.

My bad . . . . . . this pic was right before I disassembled and installed new lines

Pic of the new couplings and hoses