Recent content by Billbo

Thank you,

B2320HST. I have a filter in the left side and in the right side by rear wheels. My manual calls for a transmission filter and a hydraulic filter. Which is which please?? The book is not clear. And what are these filter numbers? Thanks

I soaked in diesel about two days. Worked the collar and the bearings. Then sprayed parts cleaner on it all - the collar and balls. I got the shaft one the tractor, but still was aggravating. I now could use a method of holding the collar back so I can use two hands to hookup. I believe...

Thanks for the reply. This cutter is used albeit very little. Appears brand new. But I have no idea how long it’s sat out in weather. The tractor end actually does slip on about an inch then hits metal - like stuck balls. I just can’t get it to move past those balls so I’m soaking it now...

CTFJR, I’m 75 and have some of the same issues you do. I only wish those PTO Links weren’t so expensive, I just bought the bush hog and those links are half what I paid for the bush hog

Thanks Wolfman. I will try that soaking idea then I may try using a small c clamp to try and push those balls down. I have sprayed parts cleaner in them but to no avail. Soaking might be the best.

Thanks for the reply. (On a land pride brush hog-tractor end) I’m talking about the pull back collar releasing the 3 bearings. I pull the collar back and get the thing to slide on maybe 1@ and it hits the bearings and stops. However, while I hold the collar back my wife tapped on the...

I would like your opinions on the PTO link as I can’t seem to use the slip rink with the ball bearings. Thank you

I have B2320 and the WSM. Where do I find the hydraulic pressure relief valve in the WSM? Tia Bill

Thank you Wolfman. Do you have any other suggestions how to make my joystick (bucket) move without sticking? Is there any thing or any where else I could lubricate???

Hello all, I read in another post a guy lubricated the balls and springs on his joystick - question for you how do you lube the springs and balls in your joystick? My joystick ‘sticks’ and when it breaks loose the bucket just jumps up of down or curl/dump!!!! Seems I can’t just ease into moving...

Hello, question for you how did you lube the springs and balls in your joystick? My joystick ‘sticks’ and when it breaks loose the bucket just jumps up of down or curl/dump!!!! Seems I can’t just ease into moving it any direction.

Thanks for that info. I ask because bolts are relatively inexpensive to replace. Tines or other parts not so much.

When I bolt on spring steel tines be it landscape rake or cultivate tines, am I supposed to use a lower grade bolt (regular bolt) so it WILL break or stronger like grade 8 so it won’t break as easy??? Thanks