Recent content by BigSteve63

Three point carry all with crate or expanded metal basket?

Forgot to mention - they tested it by mowing some of their lawn, then had me test to make sure I was satisfied with the cut. Unbelievable difference!

Good news! Dealer offered to adjust the mower; called later and said they would not be done until the next day. Turns out, the mower had not been installed or adjusted correctly. The owner personally apologized and assured me that it is not their practice to send out new equipment this way...

Dealer is going to take a look at it tomorrow. Pretty sure they will find the problem if they check. The mower was pulled from a 2320 and put on my 2920, I'm sure that they just got in a hurry and didn't completely check it out. Tehy were pretty helpful when they called me back - I offered to...

Robert, Thank you for your response. It does make sense to measure from a known distance, now that I think about it; I just got plenty frustrated while trying to measure "just like it says in the manual". I was going to measure the blade tips front to rear, but think I can get about as close...

Gents, I work for a lubricants distributor, selling several products from most of the majors. There are benefits to be had from the synthetics and synblends; I didn't believe too much of the hype until I witnessed test results that back it up. If switch to a full or blended synthetic, you and...

Have not checked the mandrels yet. I did the side to side check like recommended in the book, and that was how I discovered the difference there. Is there an easier method than lowering all the way down? I could not get my hand, let alone a tape. ruler. or other measure under there. I wound...

I recently purchased a new B2920 with a 60" Kubota belly mower. From the dealer, it was about 1" off from side to side. I am having trouble with the mower scalping and it appears to be cutting way lower than the dial adjustment indicates. Also, the mower is "streaking", or leaving visible...