Recent content by Bhouston350

Any further comment..???

Sorry, it was the coupler tip that I replaced. Dont know where my head was when I said valves..???

My M8200 has 1 set of rear remote hydraulics. One of the valves does its job; the other does not. So, when I lower the wheels (which lifts the disks) on my off-set harrows its no problem; when I go to lift the wheels (to lower the disks) its move very slowly. I switched out the valves on both...

Whitetiger - thanks for the input. But, oddly enough when I switch the coupler tips the same result occurs. The inside (right) port seems to be the problem - even when I put the coupler from the outside (left) port into the inside (right) port - same result occurs.

Hydraulic remotes in my M8200 have always worked fine. But, about 5 weeks ago, the right remote began "slowing down". It works, but goes very slow. So, if the lift function hose is attached to the right port - its lifts the disk very slowly. If I switch hoses then the lower down function runs...

I have a M8200 Utility tractor. I am looking for a loader and have been advised that it will take a LA1301 or LA 1251. Very hard to find LA1251 - but there are some LA 1301 loaders around on auction firms. Can anyone confirm that the LA 1301 will mount on the M8200..??

Did you ever get any answers to this inquiry..?? Did you get the 1301S and mount it..??

Hmmm, didnt think about that. I will ask my Georgia Kubota dealer about it. Thx.

Its definitely the Narrow M8200. No Cab (open station)

Any thoughts or info...????

Acquired my M8200 without an FEL. Really need one around the farm. Does anyone know what Kubota FEL is a match for the M8200 and any ideas on locating a used one..??