Recent content by bernhardine

If you would clean up als parts, you could see where the leak is. What's about the venttube/vent valve? Is it free or restricted?

I guess there are air-bubbles in the oil. If there is a smal leak on the suction side of the oilpump(s), you get bubbles or foam in the oil. This increases the oil volume very quick up to 115% or more. The bubbles sometimes stay in the oil fore one day or longer. If the suction side is...

I guess it didn't break during regular use!

nothing to add Your doing a great job, Wolfman, thanks!

Yes and no. In 2012 Kubota took over the "Kveneland-Group". This includes "Deutz-Fahr" Harvest with several (good) Combine models. But they don't sell them under the name Kubota. Since 2019 Kubota works together with "Bühler Industries", which is a 100% Part of "Rostselmash". They plan to...

They are still available and in the actual price list in Down Under ........ :cool:

yes. Your foot and the shuttle-neutral are using the same clutch engine - clutch - shuttle - range (groups) - main gears

1. - the range-group is not synchronized. So stop to change. 2. - It is difficult at the beginning. It'll get better, but it needs up to 400 hours. Use the range shifter as often as you can. Playing a little bit with the foot clutch while trying to change the range helps a lot. 3. - foot...

Yes, I think so. It's because the retracting speed is far to high. That builds up pressure in the other side of the cylinder because the oil can't flow out quick enough. So the checkvalve always closes and opens again rapidly.

well, it is. - We do it with every new or repaired FEL and it makes a big difference. If you cycle the bucket only with the FEL in a upper position, the air in the outcurl chamber of the cylinder stays in the opposit side of the hose connector. Curling in, the air is the last volume that comes...

One more movement is necessary. Cycle the bucket to full dump (better without bucket) and lower the loader as far down as possible. Wait about 30 seconds so the air can go to the rear and now upper end of the two cylinders. Then fully curl in. Do so two or three times.

would start with one person. A new president. (and please, not a child again!)

What parts do you need for the differential? Most parts are still available. several thousands of them were built and most of them were exported to China (Zen-Noh). These "gray market" tractors never worked in Japan!

You need 5 posts to be able to attach files or pics. So just write something .... "weather is fine" or "night was cold" ........ :rolleyes:

No. Absolutely not. It's a pure hydraulic/hydrostatic system. And this system is the only one used on these specific models worldwide! I'm pretty sure your problem is a faulty steering-cylinder at the front axle (or may be a not proper adjusted pressure relieve valve of the SCM).