Recent content by BergyPatty37

@PHPaul Contact Skowhegan Tire center. I got a 8x16 Carlisle Mounted total was $185 OTD for one side. Quoted rear 13.6-24 was about $500 per side, not loaded. But they do load tires (not sure if its on sight or not). Here is there web link: https://www.mainetirecenter.com/

@motionclone Any update? Need to replace my RH Tie Rod End # 38630-44780 and haven't found any aftermarket or cross reference. Curious how you made out, and if it worked could you provide part number? Thanks Kubota price went up to $158

Great deal on that.

Looks like your Left front tire is mounted backwards. Another advice is to get ballast weight to help keep weight on rear tires especially when doing loader work. You can either get ballast boxes, cement weights, or fill your rear tires with rimguard. Varying opinions on how much weight you need...

Here is a link to the Owners manual for the L3xx Series tractor (L305, L345, and L355): https://freshmanuals.com/manuals/kubota/Tractor-Owners-Manuals/L305_L345_L355SS-owners-manual.pdf Make sure you are paying attention to the L345DT specific information relevant to your model tractor as there...

Thanks for the help. I was able to tighten the tension nut to get proper resistance, them tighten jamnut. The lever now holds in any position i want it to be set at and won't fall with vibration like it did before.

@TheOldHokie That is pretty much how I have been using it but I was confused by the way the manual was describing it. Mostly skidding logs so I will be using the position control for that. Thanks

Thanks @North Idaho Wolfman . I was just about to go out and see if that nut would put more tension on it, then we were suppose to get some rain so decided to wait till tomorrow. I will report back. Do you happen to know how the draft control and position control levers are suppose to work in...

Hi all, My L355-SS Position control lever has no resistance and falls as soon as you let the lever go. 3 Point hitch operates fine. Is there an adjustment that I need to make to put some resistance on that lever so it does not just fall down to lower position? Thanks in Advance.

Never trust the AI information. Usually wrong and convoluted. That goes for anything.

@Snave I used to work for a independent John Deere dealer as a parts advisor. We had a 20% restocking fee on all special order items, and no return fee on electronics. While the employee should have told you this up front, you will run into this issue regardless of 'manufacturer of tractor.'...

agree with geohorn, flush with water. drain whatever is in there, fill it up with water, run it for a few minutes, then drain again.

Probably going to have a hard time unless you find someone parting out a cab. Here is the installation and parts manual for that cab. At the end of the manual they will have the part numbers listed for it. Find a local Curtis Dealer and call them to get price. I bet it will be around $1000 for...

@Andyr9981 I would suggest flushing if you are changing coolant types/manufacturers, or if you do not know what is currently in there. Otherwise if you have had tractor since new and are using Kubota recommended coolant I would think you would be ok just doing a drain in fill after 2 years. I...

@Trash Panda I was thinking the same. I watch a lot of motorcycle crash videos like dandanthefireman and usually there is at least 1 prius every new video compilation. Glad you are ok. Are you having insurance get involved? If so probably need to get a shop to go through it and make sure there...