Recent content by bambam31

Can you switch the pins to point in instead of out?

i upgraded the seat on my L3800 a few years ago. It didn’t fit very well so I returned it. One thing I noticed was the spring was not strong enough to lift the new seat and activate the seat safety switch when I stood up. Is this something you just live with or can you upgrade the spring too?

Thanks I plan to take my trailer loaded when I get the ramps modified.

The first and second pic is what I was referring to. Thx

My trailer has the stowaway ramps. I want to get a fab shop to modify them and make them into the fold down style. Here’s my question. If I add stabilizers to the ramps, how much gap in inches should I leave between the bottom of the stabilizers and the ground when trailer is not loaded? TIA

I’m with others who disliked ROPS mounted lights. I’m in south Alabama. The bugs were terrible. I‘m much happier with them mounted on the end of the canopy. What ever you do. Good luck.

I’m with dusty. A Dozier will get it done quick. I’ve never regretted calling the dozier man.

Thanks !

Where is a good place to get a replacement for my L3800? Thanks

I have 350 hours on it. Thanks for the tip on the lug nuts. I think I will get the service manual too.

Will do. I was concerned about the front axle oil. I’ve seen several videos about very low levels. Thankfully, I had plenty. I want to make this tractor last.

I successfully changed my engine oil and the front axle oil thanks to the DIY My Way YouTube channel. Check him out. He’s got some good videos.

The pin is missing but it doesn’t discharge unless the lever is depressed. it is a 2.5 lbs extinguisher and the top sticks out.

I have mine currently mounted to the ROPS with this mount. branches and brush keep pulling the pin for me. I’d like a more solid mount near the seat. Moose

that’s how I was trying to identify the right setting by driving at 25 mph and having the trailer brakes stop both the truck and fully loaded trailer. I did not make that up I think that method was in my manual. Either way, its obvious the setting is too high and a method not used my others. I...