Recent content by auctioneer dave

Does any one have a workshop manual for a Kubota L 3600 tractor that show how to take the front wheel drive propeller shaft apart to replace the O-rings on this shaft? Any information on this would be appreciated thank you in advance for in any help.

Thanks Wolman that is exactly what I need, I will let you know how this comes out and if it stops the leak hopefully I will not have to break the tractor apart, and this will fix my problem.

The leak is coming from the front wheel drive propeller shaft you are mentioning here I was hoping some one had a diagram with instructions on how to do this

I have a Kubota L 3600 tractor four wheel drive with a Hydraulic leak under the tractor around a nut with a pin in it. I went to the Kubota dealer with this is sold me a kit to fix this, this kit consist of a round tube and two o rings, but I need a break down on how to do this. there is a...

Where is this relay located that your are talking about. my L3600 is doing the same thing with the light.

Does any one know if the hydraulic fluid you buy from the Kubota dealer a thicker fluid than you would buy at tractor supply. thanks for any info that anyone can give me on this.

You might want to try what I did by going to the dealer and buying one new mine was 17.5 x 24 so it was a bigger rim. the new rim was $300.00 plus about $300.00 to $400.00 to change it and install it with fluid. I could not find a rim my size any where in the us.. new or used

I wanted to tell my story about having to replace a rusted out rear rim on Kubota L 3600. The rim I could not find a used one anywhere in the USA so I went to Kubota dealer and purchased a new one (size 17.5 X 24) for $300.00 then the service call to come out and change this out was $260.00 I...

It should have said under the center of the tractor there is a nut there that I thought was to let water out, it has a pin in the center of the nut.

I seem to have an hyd oil leak under the cylinder of the tractor, there is a nut there with a pin coming through it. It is coming from the hyd but I dont know what to do about it. thanks Dave

Does any one have grill guard plans for L3600, like where do you mount it to start I could build one if I knew where other people started to mount there's thanks dave

I am looking for a complete front grill for a L 3600, this would be the light assembly and all the metal around that. If there is any one out there that has one please email me at blackberrygrower@hotmail.com thanks Dave

I have changed a lot of hydraulic hoses before, when you take one off take it to someone in your town that makes hydraulic hoses. I have found when you find a locally owned hose fitting supply they are less expensive than other big outfits with the same hoses and fittings. When you take the hose...

Baileys in Knoxville tn I replaced both the tilt cylinders on my fel for $240.00 for both cylinders. I ordered them at 10:00 on morning and had them by fed ex the next morning. They work great

Does any one have a wiring diagram for a Kubota L 3600, that they can send me a copy of? Thanks in advance Dave