Recent content by ArticiferTom

No problem Red .. A holding tank is one that waste is dumped in until full . Then clean by septic service . If your system was installed and inspected by authority having jurisdiction they maybe be responsible for this . Unless damaged by others . In Pa . I understand each individual system...

If it is a true septic tank , it must always remain full to work . As fluid enters it exits to drain field after dropping solids . If a holding tank ,then different story , and my apologies .

Re: How to Remove D1005 engine Plug / Done Thanks Lugbolt ! Had the machine out today for short haul . So while it was warm tried again with 18" breaker only and got proper 17mm allen socket . No movement . Then heated the boss and plug edge with hand propane torch , maybe 45seconds . This...

Thanks ,Guess I'll have to drain block down . was trying to do on the quick .

How to Remove D1005 engine Plug / Done Cannot seam to get plug to let loose on side of engine to install screw in heater . With helper on 5/8" Allen socket will not move with one arm push /one counter holding . Should it be heated or what ? After reading here someone doing it last week , had...

Thanks . Glad to know they are compatible . That was biggest concern .

How can you tell difference? Not sure what been used in my recently purchase '06 B21 TBL . I understand one is synthetic , correct ? Thanks Tom

Looking for replacement base for canopy mounted tail light assembly . Can not find factory numbers for , but used on the industrial B21 TBL's in lew of fender mounts . They are large and have amber and red section , mounted in back with aux blinkers only in front .

Also think battery gases maybe be explosive . And older chargers have arcing contacts . Please read warnings !!!

Re: FS: Weights ; cases 5 Sold .. Thank you OTT

Some new LED light work on voltage ranges with out taps . So can be hooked on any voltage between it range .

You are not showing a neutral so you either need a step down transformer or 220v lamp bulb if they still make them . Some grinders have a tap off leg build in for the light , that is why they do not come on until started .

Re: FS: R1 Tires and Wheels 24" SOLD, thanks all .

Re: Tachometer pegging gauge now/ FIXED Fingers crossed! Took your advise removed cluster and used old cable in plastic sleeve, curved , drill driven . Found needle would bind and jump to peg . Noticed to be positional on how cable entered back of gage . Next disassembly confirmed dried out...

Re: FS: Weights ; cases 5 Deal fell through . KP your up Meet on PM.