armylifer's latest activity
-
-
-
-
I’ve never had that situation with R4’s. They only would be an issue is the ground was soft and wet, and anything would tear up grass...
-
armylifer replied to the thread Newbie tire questions.The R14's should be a good compromise for you. You mentioned that you are concerned about tearing up the ground in a finished area. The...
-
Properly filled tires are filled to about 75%, so there’s still an air pocket, and yes you still check and set air pressure. Always...
-
That looks like a typical petcock. The “wingnut” is all you need to turn and fluid will start coming out. They were used on radiators...
-
On my B2920, I use the loader and a chain to pick the mower up and then use my impact wrench to remove the blades. With the impact...
-
armylifer replied to the thread Orange tractor related but NOT Kubota.Your dad and my uncle started working at AC about the same time. I don't know exactly what his job was but I know that for at least...
-
armylifer replied to the thread Mid Mount Mower blades.I also do as Chim mentioned, The bolts tend to tighten up as you use the mower, rather than come loose.
-
If you do not have an impact wrench: my manual says to stop the blades from turning with a wooden block against the deck steel frame...
-
armylifer replied to the thread Mid Mount Mower blades.I am not sure what blades are used for your mower but the Oregon blades I purchased for mine are 1/4" thick...
-
armylifer replied to the thread Mid Mount Mower blades.To add to the above post, use an impact wrench to remove the blade bolts. It makes the job much easier.
-
On my BX I leave the deck on,, raise it to its highest setting and use the loader to lift the front up and remove them with the PTO...
-
