AndyM's latest activity
-
AAndyM reacted to NCL4701's post in the thread Photo shoot anything lately? Random Photo Thread with
Like.
Driving across the dam at our pond today to refresh the wood chips on a seating area, I noticed this weird looking sort of turtlish... -
AUpdate: AndyM reports the pulley is still holding up well, so I published the design and .stl print files on Printables for the next...
-
AAndyM replied to the thread Daily Chuckle.My new microwave has a helpful "Insert Food" message.
-
AAndyM replied to the thread Electric Vehicles. Can anyone make this make sense?.When a gas plant blows up, you wait a few days, bring in the dozers and rebuild. When a nuc (pick your flavor) blows up, well, you know.
-
AAndyM replied to the thread Photo shoot anything lately? Random Photo Thread.Looks like it is wearing a happy face on it's abdomen.
-
AAndyM reacted to Paul Allwood's post in the thread Photo shoot anything lately? Random Photo Thread with Like.
Some more of our local wildlife. Safely relocated from the kitchen outside into the garden. It's a huntsman, about 4" across. They hurt...
-
AAndyM replied to the thread Electric Vehicles. Can anyone make this make sense?.Modular reactors are being held out as the solution to much of this. A good discussion is here...
-
AAndyM reacted to Runs With Scissors's post in the thread Wish I had another inch or so ;) with Like.
It appears to be pretty good. I go ahead and finish boring it to the final dimension. It’s not “hydraulic cylinder” smooth, but...
-
AAndyM reacted to MapleLeafFarmer's post in the thread Unbelievable Depreciation on Some Vehicles with Like.
I'm not surprised on anything on the video list. All were either cutting edge EV stuff or exotic stuff. People make the choice to be...
-
ASay what 🤔 Whoops - I see you got an edit in... Dan
-
AAndyM replied to the thread Learn how to diagnose electrical.I only did a quick check but a no load test came back at 13.3v; with the circuit on it dropped to 12.6v. More to do, but I would...
-
AAndyM replied to the thread Learn how to diagnose electrical.Well this is timely - went to start the Polaris ATV yesterday (about 40 hrs on it) and nothing. Dash lights then, fuel pump kicks in...
-
AI have been slowly working on building a cutter grinder for sharpening endmills. It will sharpen the ends and the flutes. The spindle...
-
AAndyM replied to the thread Trying to figure out how to trench beside road….Might not apply here, but, my road ditches tend to fill with mud in the rainy season, then flood the road. Last clean was an 10" log...