Recent content by analog

I'm sorry for my ignorance, but other than an obstruction in the line, what other potential problems would cause high pressures in the system?

The 3 point does raise. It's what I was using before I went to go hook the backhoe back up.

What is pump loading? It's very uncomfortable, if I held it I'm sure I would get a burn, but I would put the temp at maybe 150 degrees if I had to guess. This is new behavior that I never noticed before when switching out the backhoe, although I can't honestly say that I have taken the...

Any particular reason why that is the only fitting that's getting hot though? All the rest of them are cool to the touch.

Today I needed to swap out the backhoe for a tiller and when I was done and needed to reconnect the backhoe, I noticed the quick connect that goes back to the tractor from itself was hot to the touch, so much so that I had to very quickly undo it so I could get the backhoe line back on. Once...

That's kind of what I think maybe a seal popped off. I did stop using it and won't use it until I get it repaired.

I was using my tractor's FEL today and I heard a loud pop up by the FEL while having the bucket about half way curled against the ground pulling backward. Immediately afterward, I can curl the bucket all the way but it starts uncurling without any weight in it, it will uncurl within probably 30...