Al38kit's latest activity
-
AAl38kit replied to the thread M7060 3PT return line blows.I found both cylinders bypassing really badly, one a bit worse than the other, so I pulled both of them... they weren't too difficult to...
-
AAl38kit replied to the thread M7060 3PT return line blows.That is correct. I’ve been chasing some issues with the three-point and hopefully I have found the problem. IF both of the 3pt...
-
AAl38kit replied to the thread M7060 3PT return line blows.Yes, massive fluid in the return line. This happened again last night as I was lifting the 10' mower. Thanks for the information.
-
AAl38kit replied to the thread M7060 3PT return line blows.
-
AAl38kit replied to the thread M7060 3PT return line blows.Thank you for the insight as to how this should work. It explains things very well...I'll check the cylinders individually tomorrow...
-
AThere is a small hydraulic return line just behind the cab. It is hooked to a T fitting and then the two lines connect to the hydraulic...
-
AAl38kit replied to the thread M7060 code 12.I'm not sure what the question is...I like distal and proximal...no Doc, or similar here. Being stuck in 4WD is the symptom of the...
-
AAl38kit replied to the thread M7060 code 12.Yes. That gives another input to the valve. It is diode protected from feeding the pto, etc. This is a bit more complicated than I had...
-
AAl38kit replied to the thread M7060 code 12.It appears I have found the problem...The machine is stuck in 4WD. I removed the floor pan and found a few wire bundles and in the one...
-
AAl38kit replied to the thread M7060 code 12.As I'm trying to track down what is probably a broken wire, I'm interested in what sends the fault code 12. The tractor throws the code...
-
-
AAl38kit replied to the thread M7060 code 12.Yes to both. There is a diode block where the brake switch enters into the equation and I believe that’s where the wire changes colour...
-
AAl38kit replied to the thread M7060 code 12.Today's report from the trenches: Through no small feat I was able to remove the connector and test it. No voltage at pin 1. The...
-
AAl38kit replied to the thread M7060 code 12.I agree completely. I tried to troubleshoot it as much as I could from the switch. It is powered and shows bus voltage and the SW...
-
AAl38kit replied to the thread M7060 code 12.I like the other guy's idea of downloading it for free.
-
AAl38kit replied to the thread M7060 code 12.I found the electrical schematic and since the connector is such a pain to get to, I think I'll initially trouble shoot it from the...
