Recent content by 4rider

  1. 4

    B7200 Hydraulic Loader Cylinder repair

    avpowerstn, THANK YOU for putting together and posting this B1630 loader cylinder rebuild procedure! Love the pictures and comments on them! I would rather see then read printed instructions.
  2. 4

    B7100 Gear oil pan gasket replacement

    Hi, does anyone have experiance with replacing oil pan gasket on B7100 gear shift? How hard is to do it? What is the procedure for doing it? My 1980 B7100have 1726 hours on the clock.
  3. 4

    BX25 Work Lights

    wills670 nice led work lights set up. I wish I have folding ROPS on my Kubota B7100 so I can make similar to yours mounting brackets. I do consider adding work lights to my tractor. How did you connect your LEDs? Did they required you to add resistors to lower the voltage? Or they have build in...
  4. 4

    Block heater installation

    Service Dept Vic, this Kubota B7100 Block Heater with OEM Part # 70090-02842 is listed here: http://www.lashleytractorsales.com/Kubota-B7100-70090-02842-0052-Block-Heater This is something different than part #70000-82500 for HST versions, but will it work for B7100DT manual gear tractors?
  5. 4

    b7100 3 pt bleed down

    After replacing the o-rings on the piston and fitting back ring too it looks like the 3PH leak is addressed:D I also used the time to replace the transmission/hydraulic fluid using Kubota Super UDT2 and clean the transmission screen filter. It's probably me, but I have the feeling the gears are...
  6. 4

    b7100 3 pt bleed down

    Thanks for the tip. I'll stop by Tractor Supply on the way home to pick up some o-rings to replace #62. I'll use a drop of glue to keep in place as I lost it once when was putting the cover back.
  7. 4

    b7100 3 pt bleed down

    Lil Foot, thanks for the quick reply. Your diagram looks nice a clean.I use the illustrated part list from Kubota's main page. When I bought my B7100 gear drive it had the signs of minor hydraulic leak from the control valve, although the tractor was so filthy, that it was impossible to tell...
  8. 4

    b7100 3 pt bleed down

    Lil Foot, I have a hydraulic leak from the cover plate on the hydraulic cylinder, under the seat on my Kubota B7100D gear drive tractor. Found and followed the suggestions in the forum and replaced the o-ring on the piston and the other one on the cylinder cover. However the hydraulic leak is...
  9. 4

    B7100 gear oil type

    Hi, I'm new owner of 1980-sh B7100DT with gear shift and wonder if someone can guide me what type gear oil to use? I'm thinking of getting 5 gallon pail since I own 1992 4Runner. Wonder if I can use 75W90 (syntetic) in the Kubota's front and rear diffs as well as front wheel gear case (left and...