#40Fan's latest activity
-
I placed an online order and have a substantial rebate that I'll never use because it is only redeemable in store. The nearest to me is... -
#40Fan replied to the thread Thinking about a hydraulic thumb for a L47.Other than just playing with it, I still haven't had a good reason to use mine yet. It is more annoying that it leaks down enough that...
-
#40Fan replied to the thread Oil pressure.I'll appease you. Put both pressure gauges on the same tee'd in port and put your oil temp in the side of the oil pan.
-
#40Fan replied to the thread Ideas wanted/needed for BH hydraulic Thumb controls..............Might look into using two hand grips/controls to push/pull the valve.
-
#40Fan replied to the thread "Drafts" question.............Normally it will just show back up when you go to the post where it was saved.
-
#40Fan replied to the thread Pistols and rifles and threading barrels.......ohhh my!!!!!.I understand, because I'm the same way. I'd still buy the barrel to start playing with your pew pew now, though. As for sayings...
-
#40Fan replied to the thread Pistols and rifles and threading barrels.......ohhh my!!!!!.After checking prices of the threaded barrels that are available that still retain the front site, I'd not waste my time on this one.
-
#40Fan replied to the thread Kx040-4 excavator engine code PO 193 won’t go away.Did you confirm that you have the .32 volts all the way back to the PCM? If so, I think you'll need a scanner to see what the computer...
-
#40Fan replied to the thread Pistols and rifles and threading barrels.......ohhh my!!!!!.I think it was Ken that posted the video of the retracting threading tool in one of OP's other threading ....thread.
-
#40Fan replied to the thread Pistols and rifles and threading barrels.......ohhh my!!!!!.https://www.pacifictoolandgauge.com/Range-Rod-17--30-Cal-Rifle_p_121061.html One of these for sure. Maybe find someone that you can...
-
#40Fan replied to the thread MX5200 Block Heater Install - Extra metal behind the freeze plug?.After looking at what the kit includes, I don't think you'll need to do anything with the block. But, I would do everything I could to...
-
#40Fan replied to the thread RUNS really Rough if you call that running.After you get the fuel out, take a small sample and see if you can light in on fire easily. That will tell you if it is gas or not.
-
#40Fan replied to the thread pressure relief tools for flat face couplers.Hook the hoses together on your implement after you remove it. Not only does it keep them clean, it keeps pressure from building up on...
-
#40Fan replied to the thread Can anyone identify the purpose of this threaded hole on a drive coupling?.If the piece you are holding in your hand is off of the pump, then no, it should not be connected (solidly) in any way to the engine...
-
#40Fan replied to the thread Custom cab.Is your garage door really only 6 foot?