Recent content by 2500hd

Thanks for all the suggestions. I checked the solenoid and it worked. The tractor fired up and is working great. I bet it was frozen. Thanks!!

Hi Guys, My b2400 was running the other day and then died. I flushed the fuel out and then hooked it up to a battery charger and heated the block with the block heater. It ran the next day and was able to idle for 20 minutes. Tried to use it and then it died. I was not able to restart the...

It needs a filter for the hydraulics. Thanks

You guys fixed it!!! 👍👏 It was the screen. This should be stickied. Why wouldn't the dealer clean the screen when they do maintenance? Also why didn't the hydraulic filter pick up all this crap? Here are some pics.

Ok I will. I didn't see that in the wsm manual. Also my tractor can move towards and back. Why would that work and not the fel or 3 point? Thanks

So far looks like the hydraulic pump is bad. I am having a mechanic look at it. This is the part number C040-37303-620 It is $775 at messicks. They said it is typically is 2 hours to replace the pump. Any thoughts? Thanks!

Around 2 quarts. Thanks

I did that without any change. Is there a screen that is in the hydraulics that I can clean out? Thanks

Hello Everyone, My trusted Mechanic is no longer working on small equipment. Does anyone recommend a good mechanic for my Kubota B2400? I am having hydraulic issues. The tractor has been to the Kubota dealer Emerichs before. I had the worst service possible with them. Thanks for the help!

OK. I hope it's something simple. Thanks

Hi Dave. Yes the hydraulic oil was genuine Kubota. Oil and filters where done too. I'm not near the tractor to find the fel number. Hoses have not been disconnected recently. No remote outlets. I believe the power steering did work. Thanks

Hi, Tractor has 900 hours on it. Last year completed the full oil change and hydraulic oil change. I was using my b2400 the other day and the FEL started to not work. It would not go up and down. Then the 3 point stopped working. I then check the hydraoulic fluid and noticed it was low so I...

Re: WTB b2400 Three point hitch Yes it worked out. Just needed a few pins and things. The next thing I need to do is to fix the hydraulics to lift the arms. Thanks

Hi guys, I have a used b2400 and I cannot get the 3 point to raise with the lever. It seems like the hydraulic line is not pressurizing. The lift lever doesn't do anything and the adjustment for the speed of the lever on the floor board doesn't do anything. What should I check? I am updating...

Re: WTB b2400 Three point hitch Yes. Thanks for sending it over. I am going to buy the rest of the parts in a week or so and get it running. Regards