Zennoh zl2201

terrywhitejr2000

New member

Equipment
Zennoh zl2201
Jun 2, 2016
18
0
0
Natchez, MS, United States
Hello all I have a zennoh zl2201 tractor, when I start it the hydros work fine. After running it for 15 minutes or so the hydros will not respond. If I turn the tractor off for a while the hydros will work the next time I try to use them. Does anyone have any idea as to what can possibly be going on?


Sent from my iPhone using Tapatalk
 

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
29,939
6,122
113
Sandpoint, ID
Either the pump is failing or more likely the 3 point control is adjusted improperly and it's overheating the relief valve and causing it to fail. ;)
 

terrywhitejr2000

New member

Equipment
Zennoh zl2201
Jun 2, 2016
18
0
0
Natchez, MS, United States
What are the chances its just a dirty screen? I have taken the screen out to clean it and upon removal I found it to be very dirty. I have ordered on from my local store but I am told it want be in until late next week. Not sure how it all plays together but I am hoping that this would be the issue.
 

bucktail

Well-known member

Equipment
L1500DT, 6' king kutter back blade, boom, dirt scoop ford disk JD212
Jun 13, 2016
1,248
187
63
MN

North Idaho Wolfman

Moderator
Staff member
Lifetime Member

Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Jun 9, 2013
29,939
6,122
113
Sandpoint, ID
Thanks where would the relief valve be located? According to the images on the web its attached to the front end loader but I dont have a loader.
The relief valve will either in the three point control or close to it, you'll have to give me some pictures of around the rear to figure out your configuration.

What are the chances its just a dirty screen? I have taken the screen out to clean it and upon removal I found it to be very dirty. I have ordered on from my local store but I am told it want be in until late next week. Not sure how it all plays together but I am hoping that this would be the issue.
Yes a dirty suction screen will play a role in bad hydraulic operations.

I also found the hydraulic fluid was the color of chocolate milk not sure if its suppose to be that color.
Yes that would denote contamination, probably water.
And water and Hydraulics do not play well together!