Obviously, people put hooks on buckets along the top. Where else would you add them to implements/attachments?
I figure once I get the welder ready to go, I might as well use up all 6. I could buy more. There seemed to be a good deal on 6 for the 5/16 variety.
So far.
1 Center of Bucket (I have two aligned with cylinders already)
2 On either side of ballast box. Mainly to hold a short piece of chain if needed. I don't usually use chain.
1 Pallet fork frame to lift in center.
2 Pallet fork frame on sides to use chain to hold a load
Other ideas?
I figure once I get the welder ready to go, I might as well use up all 6. I could buy more. There seemed to be a good deal on 6 for the 5/16 variety.
So far.
1 Center of Bucket (I have two aligned with cylinders already)
2 On either side of ballast box. Mainly to hold a short piece of chain if needed. I don't usually use chain.
1 Pallet fork frame to lift in center.
2 Pallet fork frame on sides to use chain to hold a load
Other ideas?