Trade/Swap 72” rear blade for a 60”

[DIYOrangeDave]

I have a back blade a little too big for my SCUT. I am looking for an even swap or sell the blade for $600. Pick up my location in NS. New in 2018.

.

Sent from my iPad using Tapatalk

 

[D2Cat]

There is a real simple cure for your problem. You have a 6' blade and need a 5' blade. Have someone cut off 6" from each end.

Years back I bought a 7' blade for $125. It was just too big for the mans tractor. I cut off one ft. off of each end and used it on a B6100 for years.

 

[DIYOrangeDave]

There is a real simple cure for your problem. You have a 6' blade and need a 5' blade. Have someone cut off 6" from each end.

Years back I bought a 7' blade for $125. It was just too big for the mans tractor. I cut off one ft. off of each end and used it on a B6100 for years.

I hadn’t considered that, thank you. Unfortunately it was built for a Cat 2 tractor. In order to get it set perpendicular with the top link there wasn’t much lift. It served my original purpose but not the ideal tool for finishing after my box blade. It would be nice to get a 5’ with an offset. Thanks again!


Sent from my iPad using Tapatalk

 

[DIYOrangeDave]

Blade has been sold but I am still looking for a 60” back blade with offset.


Sent from my iPad using Tapatalk