New member here.
I am about to buy my first tractor. It is a bx2200 with a Curtis cab and heater. It has the power angle plow with down pressure. This tractor has only been used to clear snow from sidewalks. It has quite a bit of surface rust on the lower third of the tractor, including underneath. It was towed from job to job on an open trailer where it caught a lot of salt spray from the road.
The 3pt hitch and pto have never been used. Could this lack of use cause any negative issues?
I have no experience with tractors and would apreciate any advice on this unit... quirks, common problems, wear points to look at, etc..
Thanks in advance for any possitive input.
I am about to buy my first tractor. It is a bx2200 with a Curtis cab and heater. It has the power angle plow with down pressure. This tractor has only been used to clear snow from sidewalks. It has quite a bit of surface rust on the lower third of the tractor, including underneath. It was towed from job to job on an open trailer where it caught a lot of salt spray from the road.
The 3pt hitch and pto have never been used. Could this lack of use cause any negative issues?
I have no experience with tractors and would apreciate any advice on this unit... quirks, common problems, wear points to look at, etc..
Thanks in advance for any possitive input.