I have a quick attach unit on my La853 loader. One of the two handles that raise and lower the pin to lock the attachment into place is missing the bolt and nuts that hold the spring in place and keep tension on the handle. There is an appx. 1/4" hole that looks like a bolt would go in, but there are no threads. In the parts diagram, there is not a replacement bolt, only the nuts and springs. Any idea where to get this piece, and how to attach it? I am assuming it is welded on, and a well broke loose at some point. Thanks for your help!
Quick Attach part
- Thread starter woodruffoutdoors
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
look on the plate behind where the hole is, can you see a plug where it's been welded?
If you can that's the pin with the stud, you will need to grind it out and replace the stud and weld it back in.
Check very closely as some pins are just driven in.
Pictures would help.
If you can that's the pin with the stud, you will need to grind it out and replace the stud and weld it back in.
Check very closely as some pins are just driven in.
Pictures would help.
Her are a couple of pictures of the broken quick attach. I also included a picture of the unaffected side.
