Hi,
I saw early on that there was a question about this tractor having a pilot bushing or bearing to support the front of the transmission input shaft...
Does it require a pilot bushing?????
Did you measure the ID of the crankshaft/flywheel bore and the OD of the input shaft to see what the clearance is?????
If it requires a pilot bushing/bearing and it was not installed the misalignment at the front of the input shaft will break out the center of your clutch disc.....
It would be better and cheaper to find out now rather than later..
Just trying to help,
Bob
I saw early on that there was a question about this tractor having a pilot bushing or bearing to support the front of the transmission input shaft...
Does it require a pilot bushing?????
Did you measure the ID of the crankshaft/flywheel bore and the OD of the input shaft to see what the clearance is?????
If it requires a pilot bushing/bearing and it was not installed the misalignment at the front of the input shaft will break out the center of your clutch disc.....
It would be better and cheaper to find out now rather than later..
Just trying to help,
Bob