I have a L2550DT-GST that seems to have a defective clutch safety switch. When starting I have to engage the clutch 1-6 times while holding the ignition key to the start position. It appears that the switch must be bad, but I can not locate where the switch is in order to replace it. Any help would be appreciated.
L2550dt-gst
- Thread starter Dozer
- Start date
Hi Dozer,
Unfortunately, the pictures in the workshop manual are not too good. Here is the page for the L2550. Hope it helps.
Phil
Unfortunately, the pictures in the workshop manual are not too good. Here is the page for the L2550. Hope it helps.
Phil
Attachments
Milo Holroyd
Member
Lifetime Member
Equipment
1979 L245DT w/1700 FEL, 2003 L3130 HST,w/ LA723 loader,,and L2174A snowblower
I just did that adjustment on my Uncles L2550 GST. The switch is located behind the sheet metal on the left (clutch pedal) side. Ya have to take quite a few fasteners off to get to it.
Just start taking out the obvious ones, wiggling the sheet metal as you go.
Note: one piece of the sheet metal goes all the way across the top of the gear box, with fasteners on the right side.
Sounds like a pain in the butt, but it's not that bad.
Just start taking out the obvious ones, wiggling the sheet metal as you go.
Note: one piece of the sheet metal goes all the way across the top of the gear box, with fasteners on the right side.
Sounds like a pain in the butt, but it's not that bad.