how to replacement Ignition Switch

[Spinoza]

Hi Folks, will somebody help me with Instructions as to how to replace my Ignition Switch on Kubota L2900. A reference to where I might purchase a new one, also, Thank you.

 

[North Idaho Wolfman]

Your going to have to be a little more clear as kubota never made a L900.

And I'm not going to guess what model you really have, as you didn't even put it in your profile.

 

[Spinoza]

Your going to have to be a little more clear as kubota never made a L2900.

And I'm not going to guess what model you really have, as you didn't even put it in your profile.

Sorry I mistyped. It is the L2900

 

[Bulldog]

Should just have to screw the ring off the front where the key goes in and slip it out of the dash. I don't know if it plugs in or wires in, I've seen both. If it wires in do one wire at a time and transfer them to the new switch so you don't get anything mixed up.

New switch, I'd just go to your local dealer if possible that way you know you're getting the correct part.

 

[Russell King]

You may also have to figure out how to remove the dash to be able to access the rear side to install the switch


Sent from my iPad using Tapatalk

 

[lugbolt]

Step 1: remove old switch.

Step 2: install new switch.

 

[chief36chevy]

Can someone help me how I can remove the ignition switch on a BX2360? I tried to remove the outer ring but was scared the I would break it.

 

[OrangeDragon]

Step 1: remove old switch.

Step 2: install new switch.

Einstein? Is that you?

 

[GreensvilleJay]

re:bx2360
from parts diagram....possibly
remove under dash screen
disconnect battery
remove ign sw trim nut
push through hole
unplug switch from harness...

seems that simple

 

[mikester]