Hard to shift into High

[Chew]

Hi folks. I have a 2008 L3400 (DT/standard shift). Just recently it has become almost impossible to put it in High. It goes into low, neutral, reverse just fine but when I move it over and try go to high it's binding up. I've sprayed all the connections/pivots I can see with Lithium Grease. Didn't help. Did I damage or Bend something? Any suggestions? Thanks.

 

[1970cs]

It appears that the range shift runs on the same rail. If it's binding? Then I would try pull the speed change shift cover and see if can see the range shift syncro and gear for high range. I would suspect one or both are rounded off.

Pat

 

[Chew]

It appears that the range shift runs on the same rail. If it's binding? Then I would try pull the speed change shift cover and see if can see the range shift syncro and gear for high range. I would suspect one or both are rounded off.

Pat

Thanks sir. I'm new to tractors and not sure where all those are but I can probably figure it out

 

[Chew]

Any other input?